D-Think_NFC010 NFC读写模块，支持模拟卡

      D-Think_NFC010模块主核心采用NXP第二代NFC控制器PN544(PN65N)， NFC功能最完整，尺寸小，并集成了部分外围元件，采用3MIL线宽/间距生产工艺，缩短了开发周期，降低了开发难度。

产品编码	D-Think_010_PN65N
协议标准	ISO/IEC 14443A，ISO/IEC 14443 B，ISO/IEC 15693， ISO/IEC 18092，FeliCa，Mifare 1K/4K
工作频率	13.56MHz
识别距离	5-8CM
安全模块	有
供电	USB供电
外围芯片接口	SWP、NFC‐WI
通讯接口	UART、I2C、SPI
电气特性	与PN544(PN65N)相一致，见PN544(PN65N)数据手册
外型尺寸	15*18*1.9mm
工作温度	-40 - +65 ℃
储存温度	-25 - +85 ℃

产品特点

• 支持读写NFC芯片
• 支持读写智能卡芯片
• 支持二次开发
  

产品应用

• 各类快速支付
• 各类身份认证
  

传输模式

引脚定义

引脚号	引脚名称	类别	描述	备注
1	GND	Other	Ground
2	NC	NC
3	EXT_SW_CTRL	UICC	Control output signal for  external UICC power switch
4	NC	NC
5	NC	NC
6	NC	NC
7	NC	NC
8	A0/NSS    (IF0)	Host	Functionality depends on  selected interface
9	NC	NC
10	NC	NC
11	NC	NC
12	NC	NC
13	NC	NC
14	IFSEL2	Configuration	Host interface select input  2
15	IFSEL1	Configuration	Host interface select input  1
16	RST_N	SE	RST pin of ISO IEC 7816  interface of SmartMX	仅PN65N
17	VMID	Antenna	Contactless receiver Voltage  reference
18	RX	Antenna	Contactless Receiver input
19	PF1	Antenna	Antenna connection for card  emulation
20	NC	NC
21	TX1	Antenna	Contactless Transmitter  output 1
22	TX2	Antenna	Contactless Transmitter  output 2
23	PF2	Antenna	Antenna connection for card  emulation
24	GND	Other	Ground
25	NC	NC
26	SIGIN	SE	NFC-WI data input
27	VEN_MON    (LX)	Other	DCDC coil	PN544
			Enable of the battery  voltage  monitor	PN65N
28	I/O1	SE	IO pin of  ISO IEC 7816 interface of SmartMX	仅PN65N
29	VBAT	Power	Battery voltage
30	SIGOUT	SE	NFC-WI data output
31	SVDD	SE	SmartMX power,fixed to 1.8V
32	SWP	UICC	SWP data connection
33	SIMVCC	UICC	Power output to supply the  UICC
34	VEN	Host	Enable/disable LDO regulator
35	PMUVCC	Host	UICC Power in from mobile  PMU
36	CLK	SE	CLK pin of ISO IEC 7816  interface of SmartMX	仅PN65N
37	NRESET	Host	PN544有用，PN65N中接PVDD
38	NC	NC
39	SDA/SCK    (IF2)	Host	Functionality depends on  selected interface
40	PVDD	Host	Pad supply voltage  Input(VI/O)
41	RXD/A1/MOSI    (IF1)	Host	Functionality depends on  selected interface
42	IRQ	Host	IRQ output
43	TXD/SCL/MISO    (IF3)	Host	Functionality depends on  selected interface
44	IFSEL0	Configuration	Host interface select input  0
45	GPIO5	GPIO	Run  mode   selection	仅PN65N
46	GPIO4	GPIO	Download  mode control	仅PN65N

引脚功能

类别	引脚名称	引脚号	描述	备注
Host    connection pins	VEN	34	Enable/disable LDO regulator
	PVDD	40	Pad supply voltageInput(VI/O)
	PMUVCC	35	UICC Power in from mobile  PMU
	IRQ	42	IRQ output
	TXD/SCL/MISO    (IF3)	43	Functionality depends on  selected interface
	SDA/SCK    (IF2)	39	Functionality depends on  selected interface
	RXD/A1/MOSI    (IF1)	41	Functionality depends on selected  interface
	A0/NSS    (IF0)	8	Functionality depends on  selected interface
	NRESET	37	PN544有用，PN65N中接PVDD
UICC    connection pins	SIMVCC	33	Power output to supply the  UICC
	SWP	32	SWP data connection
	EXT_SW_CTRL	3	Control output signal for  external UICC power switch
SE    connection pins	SVDD	31	SmartMX power,fixed to 1.8V
	SIGIN	26	NFC-WI data input
	SIGOUT	30	NFC-WI data output
	CLK	36	CLK pin of ISO IEC 7816  interface of SmartMX	仅PN65N
	I/O1	28	IO pin of  ISO IEC 7816 interface of SmartMX	仅PN65N
	RST_N	16	RST pin of ISO IEC 7816  interface of SmartMX	仅PN65N
Antenna    connection pins	TX1	21	Contactless Transmitter  output1
	TX2	22	Contactless Transmitter  output2
	RX	18	Contactless Receiver input
	VMID	17	Contactless receiver Voltage  reference
	PF1	19	Antenna connection for card  emulation
	PF2	23	Antenna connection for card  emulation
GPIO    pins	GPIO4	46	Download  mode control	仅PN65N
	GPIO5	45	Run  mode   selection	仅PN65N
Configuration pins	IFSEL0	44	Host interface select input  0
	IFSEL1	15	Host interface select input  1
	IFSEL2	14	Host interface select input  2
Other pins	VBAT	29	Battery voltage
	GND	1	Ground
	GND	24	Ground
	VEN_MON    (LX)	27	DCDC coil	PN544
			Enable of the battery  voltage  monitor	PN65N
NC	NC	2
		4
		5
		6
		7
		9
		10
		11
		12
		13
		20
		25
		38